Ceiling panels. The one on the left shows the outside and a vent opening, it goes in the center. The one on the right is the inside and goes on first. I spaced the spars closer together in the curves and farther apart for the straights. I left them far enough apart for the vent. Viewed: 236 times.
|
Last Ceiling panel. Need only about 2 feet. Left the last (oak) support off so it can be placed properly. Will attach the support to the walls and then attach the ceiling panel to the support and route it off. Viewed: 202 times.
|
Installing a ceiling panel Viewed: 237 times.
|
Glued and screwed this panel to the floor and the walls.
You can sure see the top of the carriage bolts under the vinyl flooring. Viewed: 256 times.
|
First ceiling panel on. Installed the top screw on each spur until the bend is done then wento back and installed the bottom screw. Viewed: 248 times.
|
IMG 0035 Viewed: 248 times.
|
Slight crack. I made several horizontal score marks across the back and this seemed to stop the crack. Viewed: 263 times.
|
Clamped the right wall since it was square to the floor. Moved the other wall in to fit. Viewed: 267 times.
|
trying to show the wall curve. Viewed: 281 times.
|
