Inside wall finished with spar urethane (two coats, sanded in between).
We cut the flooring to length by cutting the back square and then clamping a 1 x 2 board on the back and pushing the floor against the board and then cutting the front off square. Then we removed the board and pushed the flooring square to the back to install.
This kept the flooring out from under the front roof/ceiling. This worked well. Cutting the sides was more difficult. Viewed: 320 times.
|
More flooring. Julie did a nice job with the wall finish. The carriage bolt tops and floor seams show through the flooring. Viewed: 374 times.
|
