| | | | |
|
|
|
|
|
|
Tools to make the front 20" radius 90-degree arc. Viewed: 223 times.
|
Tools used to make the hatch arc (plus a pencil). Viewed: 209 times.
|
hatch arc. Viewed: 199 times.
|
I am using screws in the scrap area and clamps in the good area to hold the two wall pieces together so I can cut them at the same time. Viewed: 195 times.
|
Practice cut. Viewed: 226 times.
|
| | | | |
| | | | |
|
|
|
|
|
|
Using a flush router bit to square the edge. Viewed: 232 times.
|
Ahhh! Better! Viewed: 232 times.
|
Front cut, routed and sanded Viewed: 207 times.
|
Back cut, routed and sanded Viewed: 209 times.
|
Left wall inside Viewed: 208 times.
|
| | | | |
| | | | |
|
|
|
|
|
|
Right wall inside. Dado slot for the bulkhead stop. Dado slot for the floor.
Needed more clamps so I can cut out door. They are on order and should be here next week.
Viewed: 261 times.
|
Bulkhead stop is installed. Shelf support is installed. I ended up extending the shelf farther so I should have made the shelf support and slot longer. That's what you get for putting the galley design off. Viewed: 277 times.
|
This is exactly when people started stopping and asking questions. Viewed: 268 times.
|
IMG 0018 Viewed: 333 times.
|
Its Square!!!! Viewed: 262 times.
|
| | | | |
| | | | |
|
|
|
|
|
|
Clamping the wall square to the floor in the back Viewed: 234 times.
|
Clamping the wall square to the floor in the front Viewed: 229 times.
|
Left wall up. Viewed: 244 times.
|
IMG 0024 Viewed: 260 times.
|
IMG 0025 Viewed: 251 times.
|
| | | | |
| |
|
|
|
Ron ready to sand the side Viewed: 228 times.
|
Ron sanding the side Viewed: 245 times.
|
| |
